Pointers on Applying Flower Inducer to Mango Trees

Simultaneous fruiting is possible nowadays with flower inducer. By spraying it to mango trees, not just more, but bigger fruits are produced.

Potassium nitrate is the generic name of chemical flower inducer in mango, and the chemical symbol for this compound is or KNO;. It contains 13% nitrogen and 46% potash, hence it is also called 13-0-46. KNO supplies the potassium requirement of the tree and in the process, induces flowering.

Another flower inducer used, nowadays is calcium nitrate (CaN). It contains 45% calcium and 15% nitrogen. It is affordable, yet the effect is just the same.

Here are some pointers on applying flower inducer to mango trees.

1. Flowering and fruiting vary, depending on the variety.
2. Chemical flower inducers should not be used under the following circumstances:

• when the tree is 10 years old or below
• when the leaves and buds are young
• when the tree is weak and sickly
• during rainy days

3. High dosage of flower inducer should be applied when the tree is healthy and starting to mature, the leaves and buds are maturing, and the weather is cloudy.
4. Use low dosage of flower inducer (1% – 2% of KNO;) when the tree is already mature, healthy, and has dormant buds; the leaves and buds are mature; and the weather is sunny.
5. Induce flowering once a year. However, if it did not flush during the fruiting time, spray again after harvest, but do not expect full bloom.
6. Spraying should be done when the tree and leaves are dry, and with no expected rain within the next six hours.
7. Use Apsa-80 as sticker.
8. Using the same formulation, spray again after two days to hasten the emergence of flowers.
9. From flowering to harvest, it takes 7 to 8 months to rejuvenate and accumulate nutrients for the next fruiting season.
10. Trees that have yielded in the previous season but have not flushed can be induced, but do not expect a full bloom.

In spraying potassium nitrate, prepare a 1% – 3% solution, depending on the condition of the tree. Or, mix 4 kilos per 200 liters of water. Spray it onto the leaves and branches, totally wetting but not dripping. Spray early in the morning (from sunrise to 9:00 a.m.) or late in the afternoon (from 4:00 p.m.-6:00 p.m.) to prevent leaf burning due to sunlight. In applying CaN, one one hand, mix 5 kilos to 200 liters of water.

After 12 days, when the flowers start to emerge, spray pesticide and fungicide. The flowers would be fully opened after 20 days. At this time, the flowers are susceptible to pest, so inspect the plants every day to see if there are damages caused by insects, and spray appropriate pesticide.